Plasma Cutting Explained: What To Consider Before You Invest

Before choosing a machine, it's worth checking what your workshop's consumer unit and incoming supply can actually handle, not just what socket is nearest the bench. Buying a three-phase-only machine for a single-phase workshop, or underestimating the load a higher-output single-phase welder places on existing wiring, are both avoidable problems with a bit of checking upfront.

Plasma cutting uses a jet of ionised gas, usually compressed air, forced through a nozzle at high speed and heated by an electric arc to a temperature hot enough to melt through electrically conductive metal. The molten material is then blown clear by the same jet, leaving a narrow, clean cut. Unlike oxy-fuel cutting, plasma works on any conductive metal, including stainless steel and aluminium, not just carbon steel. Hypertherm is the plasma cutting brand we get asked about most, and it's worth understanding the basics before comparing specific units.

Keeping a stock of the right tungsten types, collets and gas lens sizes for the work you do avoids a lot of avoidable downtime, and it's the sort of consumables range worth sourcing from a specialist supplier like welding machines.

A welding table is easy to overlook when planning a workshop, yet a poor one undermines accuracy on every job that touches it. If the surface isn't flat, nothing clamped or squared against it will be either, and small errors compound quickly on anything with multiple joints or angles.

For anyone starting out, talking through process, budget and set-up with people who deal with first-time buyers regularly is generally worth more than another hour of reading spec sheets, and that's exactly the sort of conversation the advice line at welding machines is there for.

Shade range and sensor count are the two specifications that matter most in daily use. A wider variable shade range lets one helmet cover a broader spread of processes and amperages, from low-amp TIG work through to higher-output MIG or MMA, without swapping cartridges. More sensors generally mean the filter is less likely to miss a low-angle arc or a strike caught at an awkward viewing angle, which matters most for TIG welding where the arc can be harder for a sensor to pick up cleanly.