TIG Welding Consumables: Tungsten, Collets And Gas Lenses Explained

The practical difference comes down to what a machine can draw and sustain. A single-phase supply has a ceiling on how much continuous power it can deliver before tripping breakers or overloading domestic wiring, which is why the highest-output welding and cutting equipment is frequently three-phase only, or offers noticeably better duty cycle performance when run on three-phase. For workshops without an existing three-phase supply, bringing one in usually means an electrician and, in some cases, an application to the local distribution network operator.

TIG welding relies on a handful of small consumable parts inside the torch that have an outsized effect on how the arc behaves. The tungsten electrode itself doesn't melt into the weld; it simply carries the arc, and different tungsten types, distinguished by their alloying elements, suit different current types and materials. Getting the wrong tungsten for the job typically shows up as arc wander or poor arc starts long before it shows up anywhere else.

Space and power supply are the other two practical constraints worth checking early. Confirming that a chosen machine will run comfortably from the electrical supply actually available in the workshop, and that there's room to work safely around it with materials laid out, avoids the common mistake of buying a machine that then can't be used the way it was intended.

Cutting capacity is usually described in terms of clean cut and maximum cut thickness, and the two are worth distinguishing. Clean cut is the thickness a machine handles with a good edge finish and reasonable speed, while maximum cut is the thickest material the machine will get through at all, usually slower and with a rougher edge. Buying with your typical material thickness in mind, rather than the thickest job you might occasionally face, generally gives a better day-to-day result.

The figure changes with output. Turn the amperage down and the duty cycle climbs, because the internal components are working less hard. This is why a welder can feel completely different in a busy production environment compared with occasional home workshop use: someone welding continuously through a shift needs a much higher duty cycle at their working amperage than someone doing short repair jobs a few times a week. It's the kind of spec worth comparing properly across brands such as Kemppi and EWM, not just reading off the headline amperage figure.

An auto-darkening welding helmet uses a liquid crystal filter that switches automatically from a light state to a dark shade the instant it detects an arc, tecproducts.co.uk then reverts once the arc is gone. This replaces the older habit of flipping a fixed-shade visor down and up by hand, which meant either welding blind for a split second or lifting the helmet to check your position before striking the arc. 3M Speedglas is one of the ranges we point people towards most often for this, alongside other options across different budgets.