TIG Welding Consumables: Tungsten, Collets And Gas Lenses Explained

Surface flatness and tolerance are the starting point, but fixturing is what turns a flat plate into a genuinely useful tool. Tables with a grid of holes or T-slots let you bolt down clamps, stops and jigs in repeatable positions, which speeds up repetitive fabrication and makes it far easier to hold parts square while tacking. A table without any fixturing options usually ends up needing extra clamps, magnets or improvised supports to achieve the same result.

Portability and durability matter depending on how the table gets used. A shop building large frames or vehicle chassis needs a solid, well-supported table that won't flex under load, while a mobile fabricator or someone working across multiple sites benefits more from a lighter, foldable design. Material and construction quality affect long-term flatness too, since a table that warps under heat from repeated welding stops being reliable exactly where it matters most.

The practical difference comes down to what a machine can draw and sustain. A single-phase supply has a ceiling on how much continuous power it can deliver before tripping breakers or overloading domestic wiring, which is why the highest-output welding and cutting equipment is frequently three-phase only, or Tec Products Ltd offers noticeably better duty cycle performance when run on three-phase. For workshops without an existing three-phase supply, bringing one in usually means an electrician and, in some cases, an application to the local distribution network operator.

Cutting capacity is usually described in terms of clean cut and maximum cut thickness, and the two are worth distinguishing. Clean cut is the thickness a machine handles with a good edge finish and reasonable speed, while maximum cut is the thickest material the machine will get through at all, usually slower and with a rougher edge. Buying with your typical material thickness in mind, rather than the thickest job you might occasionally face, generally gives a better day-to-day result.

Portability and power supply matter as much as the process itself. A stick welder will run from a generator or a domestic supply in places a gas bottle can't easily follow, while MIG and TIG set-ups need a gas cylinder and, for anything beyond light-gauge work, a heavier electrical supply. Workshop layout, the materials you weld most often, and how frequently the machine needs to travel are all worth weighing up before settling on one process.

TIG welding relies on a handful of small consumable parts inside the torch that have an outsized effect on how the arc behaves. The tungsten electrode itself doesn't melt into the weld; it simply carries the arc, and different tungsten types, distinguished by their alloying elements, suit different current types and materials. Getting the wrong tungsten for the job typically shows up as arc wander or poor arc starts long before it shows up anywhere else.