Choosing A Welding Helmet: Auto-Darkening Lenses Explained
Plasma cutting uses a jet of ionised gas, usually compressed air, forced through a nozzle at high speed and heated by an electric arc to a temperature hot enough to melt through electrically conductive metal. The molten material is then blown clear by the same jet, leaving a narrow, clean cut. Unlike oxy-fuel cutting, plasma works on any conductive metal, including stainless steel and aluminium, not just carbon steel. Hypertherm is the plasma cutting brand we get asked about most, and it's worth understanding the basics before comparing specific units.
The abrasive material itself matters as much as the shape. Discs formulated for steel typically contain aluminium oxide, while stainless steel usually calls for an inox-rated disc that's free from iron, sulphur and chlorine contaminants that could otherwise cause surface corrosion on the stainless. Aluminium and other soft, non-ferrous metals need their own dedicated abrasives too, since standard steel discs tend to clog quickly and produce a poor finish on softer materials.
The practical difference comes down to what a machine can draw and sustain. A single-phase supply has a ceiling on how much continuous power it can deliver before tripping breakers or overloading domestic wiring, which is why the highest-output welding and cutting equipment is frequently three-phase only, or offers noticeably better duty cycle performance when run on three-phase. For workshops without an existing three-phase supply, bringing one in usually means an electrician and, in some cases, an application to the local distribution network operator.
Getting the air supply, cutting capacity and portability right for your workshop is easier with some guidance up front, and that's the kind of buying question the team at fume extraction systems are set up to help with.
Before choosing a machine, it's worth checking what your workshop's consumer unit and incoming supply can actually handle, not just what socket is nearest the bench. Buying a three-phase-only machine for a single-phase workshop, or underestimating the load a higher-output single-phase welder places on existing wiring, are both avoidable problems with a bit of checking upfront.
An auto-darkening welding helmet uses a liquid crystal filter that switches automatically from a light state to a dark shade the instant it detects an arc, then reverts once the arc is gone. This replaces the older habit of flipping a fixed-shade visor down and up by hand, which meant either welding blind for a split second or lifting the helmet to check your position before striking the arc. 3M Speedglas is one of the ranges we point people towards most often for this, alongside other options across different budgets.